Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You might discover that your garage door opener has been offering you problems, so you need to fix it. You can repair it by replacing a circuit card, a photo-eye sensing unit, the primary drive equipment, or the set-limit switches. You can also inspect if the safety sensors are working correctly.

Changing a motherboard

Replacing a motherboard for your garage door opener needs a couple of actions and also devices. Initially, you need to turn off the breaker and also separate any kind of cables. Next off, open the circuit board cover. This will assist you to detect the issue and figure out if you require a new board. Next, remove the old board and its wire ports.

You can then proceed to replace the circuit card. The replacement process is very easy and also takes around 10 mins. A brand-new motherboard will cost regarding $80. To protect your new circuit board from power rises, you can buy a rise protector.

Changing a photo-eye sensor

Replacing a photo-eye sensing unit can be a relatively basic job. First, eliminate the sensing unit from the door and also ensure it is located appropriately. If the sensor is angled by any means, it might not be getting the correct signal, which might be causing the strobe lights. If you discover that the photo-eyes run out alignment, you may need to have a service technician come as well as repair the problem.

The photo-eye sensor includes two pieces that place outside of the door tracks as well as toward the flooring. The picture eyes will certainly have a little LED light and also need to be solid in color. If the light is blinking, its most likely the photo-eye is faulty as well as will certainly require to be replaced.

Changing a major drive equipment

To replace a garage door opener primary drive gear, start by getting rid of the cap from the chain pulley-block. Next off, remove both screws holding the drive equipment to the gear assembly. Currently, you can unfasten the three tension pins. Press them from both sides and afterwards remove them. Then, detach the three cables from the garage door opener motor. These wires must be white, red, as well as blue.

When you have eliminated the old gear, mount a new one. Make certain to grease it well. Put the new equipment into the shaft, seeing to it to line up the installing holes. Make certain the gear as well as gear setting up are located correctly to make sure smooth procedure. Next off, make use of a hammer as well as a nail to drive a pin into the new equipment.

Adjusting the set-limit switches

The very first thing you ought to do if your garage door is not working correctly is to inspect the set-limit switches. You may need to adjust them to make sure that the door closes earlier or stops before it reaches the floor. You can check this by considering your garage doors guidebook or online.

To adjust the set-limit switches, youll require a screwdriver or socket. Readjust the handle clockwise or counterclockwise until the door moves up and stops, or lowers its distance. To check for proper traveling distance, measure the gap from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Key St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Garage Door Repair Garage Door Repair near me